Trailering - TOHATSU MFS 4C Manual Del Propietário

44
REMOVING AND CARRYING THE OUTBOARD MOTOR
ENON00021-1
Note
If the outboard motor must be laid
down be sure drain the fuel, then the
port side faces down as shown in the
following drawing.
Elevate power unit 2 inches to 4 inches
if traveling to avoid oil spillage.
8
ENOM00072-A

3. Trailering

ENOW00072-0
Trailering in the tilted position may cause
damage to the outboard motor, boat, etc.
ENOW00073-A
Be sure to disconnect fuel connector except
when operating engine.
ENOF01511-0
ENOF01512-0
CAUTION
WARNING
Fuel leakage is a fire or explosion hazard,
which can cause serious injury or death.
ENOW00068-0
WARNING
Close air vent screw of fuel tank and fuel
cock before carrying or storing outboard
motor and fuel tank, or fuel may leak, poten-
tially catching fire.
ENOW00071-0
CAUTION
The tilt support device supplied on your out-
board motor is not intended for towing. It is
intended to support the outboard motor
while the boat is docked, beached, etc.
ENOW00072-A
CAUTION
When trailering the outboard motor should
be in a vertical (normal running) position,
fully down. Trailering in the tilted position
may cause damage to the outboard motor,
boat, etc.
If trailering with outboard motor fully down
is not available (the gear case skeg is too
close to the road in a vertical position), fix
the outboard motor securely using a device
(like a transom saver bar) in the tilted posi-
tion.
ENOF00075-1