Starting The Engine - TOHATSU MFS 4C Manual Del Propietário

32
ENGINE OPERATION
And then, connect the fuel connector
to the fuel tank side.
1
1. Fuel connector
2. Push
3. Insert
7
1. Pull
2. Insert
5. Squeeze primer bulb until it becomes
stiff to feed fuel to carburetor. Direct
arrow mark upward when priming.
1. Engine side
2. Fuel tank side
Do not squeeze primer bulb while engine
running or when the outboard motor is
tilted up. Otherwise, fuel could overflow.
2 2
ENOF00423-0
2
1
ENOF00861-A
1
2
ENOF00862-0
ENOM00045-C

2. Starting the engine

ENOW00036-A
When the engine is started in the test tank,
to avoid over heating and water pump dam-
3 3
age, be sure the water level is at least 10 cm
(4 in.) above the anti ventilation plate.
And be sure to remove the propeller, when
starting the engine in the test tank. (See
page 58)
Run the engine only at idling.
3
2
1. Test tank
2. Water
3. Over 10 cm (4 in.)
ENOW00036-0
Be sure to stop engine immediately if cooling
water check port is not discharging water,
and check if cooling water intake is blocked.
Operating engine could lead to overheating
potentially leading to engine damage. Con-
sult an authorized dealer if the cause cannot
be found.
CAUTION
1
ENOF00863-0
CAUTION