Periodic Inspection - TOHATSU MFS 4C Manual Del Propietário

ENOM00431-0

2. Periodic Inspection

It is important to inspect and maintain your outboard motor regularly. At each interval
on the chart below, be sure to perform the indicated servicing.
Maintenance intervals should be determined according to the number of hours or num-
ber of months, whichever comes first.
Description
*1
Carburetor
Fuel filter
Piping/Hoses
Fuel System
Fuel tank
Fuel tank cap
*1
Fuel pump
Spark plug
Ignition
*1
Ignition timing
Starting Sys-
Starter rope
tem
Engine oil
Engine
Valve Clearance
*1
Thermostat
Propeller
Gear oil
Lower Unit
*1
Water pump
*1
Warning System
Bolts and Nuts
Sliding and Rotating Parts.
Grease Nipples
Outer Equipment
Anode
*1: Have this handled by your dealer.
Inspection intervals
First 20 Every 50 Every 100
hours of 1 hours of 3 hours of 6
month months months
Replace Replace
*1
Replace Replace
INSPECTION AND MAINTENANCE
Every 200
Inspection procedure
hours of 1
year
Strip, Clean, and adjust.
Check and clean or Replace if neces-
sary.
Check and clean or Replace if neces-
sary.
Clean
Check and clean or Replace if neces-
sary.
Check and clean or Replace if neces-
sary.
Check gaps.
Remove carbon deposits or Replace if
necessary.
Check timing.
Check for wear or chafing.
Replace
Replace if necessary.
Check & adjust.
Check and Replace if necessary.
Check for bent blades, damage, wear.
Change or replenish-oil and check for
Replace
water leaks.
Check for wear or damage.
Check function.
Retighten
Apply and pump in grease.
Check for corrosion.
Check for corrosion and deformation.
53
Remarks
Entire cartridge
Disassemble and
check each 300
hours.
0.8–0.9 mm
(0.031–0.035 in)
IN:
0.06–0.14 mm
(0.0024–0.0055
in)
10
EX:
0.11–0.19 mm
(0.0043–0.0075
in)
195 mL (6.6 fl.oz)
Replace impeller
every 12 months.
Replace if neces-
sary.