Stihl MS 260 Manual De Instrucciones página 29

Engfish / USA
• Remove the tensioning gear (4)
and turn it over.
• Unscrewthe nut (5).
6
Position the tensioning gear (4)
against the guide bar (6) so that the
stud (7) projects through the upper
hole and the short guide peg (8)
locates in the lower hole.
o
ca
• Screw the nut (5) on to the stud as
far as stop.
/_k Wear work gloves to protect your
hands from the sharp cutters.
• Fit the chain - start at the bar nose.
Pay attention to the position of the
tensioning gear and the cutting
edges.
• Turn the tensioning gear (4)
clockwise as far as stop.
28 MS 260