Information Before You Start; Starting / Stopping The Engine - Stihl MS 260 Manual De Instrucciones

Engfish / USA
Information
Before You Start
Starting / Stopping
the Engine
0
T
)\(
H
The four positions of the
Master Control lever
0 = Engine off-
ignition is switched off.
"[ = Normal run position -
engine runs or can fire.
To move the Master Control tever from ]"
to }'*,{ or I"'l, press down the throttle
trigger interlock and squeeze throttle
trigger at the same time.
I_,{=Warm start- this position is used to
start a warm engine. The Master
Control lever moves to the normal
run position as soon as the throttle
trigger is squeezed.
I_-I=Cold start-this position is used to
start a cold engine.
Models with decompression
valve
• Press in the button to open the
decompression valve.
The decompression valve closes as
soon as the engine fires.
• For this reason you must press in
the button before each starting
attempt.
All
models
Observe safety precautions - see
chapter "Safety precautions and
working techniques".
Push hand guard (1) forward:
The chain is now locked.
Press down trigger interlock (2) and
squeeze throttle trigger (3) at the
same time.
Set Master Control lever to:
for cold start
I'--I
for warm start 1_,1
(even if engine has been running
but is still cold),
38 MS 260