6.2
Panel 1 or panel 2 of two panels
DIP switch settings:
1 2
6.3
Control of the propulsion engine by the joy-stick
DIP switch settings:
3
• Re-install rubber plug at the rear side of the panel.
7
Actuator unit
The actuator unit is required for mechanical control of throttle and
gearbox.
The actuator unit is intended to operate inboard diesel engines. If
you wish to use this unit for operating gas or petrol engines then
the unit must be situated outside those areas with increased ex-
plosion risk. Take note here of the valid regulations for areas with
increased explosion risk.
7.1
Location of actuator unit
Select a place for the actuator in the engine room as close as possible
to the propulsion engine but in an easily accessible position.
Avoid a location where the actuator unit may be exposed to exces-
sive heat (engine exhaust) or vibrations (on the engine itself ).
vetus® Installation Manual V-docker
PANEL 1
JOY STICK CONTROLS THE
PROPULSION ENGINE
D
anger
1
2
3
Do not install the actuator unit to the selected location yet!
Preliminary
ENGLISH
PANEL 2
JOY STICK DOES NOT CONTROL
THE PROPULSION ENGINE
n
oTe
020702.01
25