Orientation Of The Appliance - Hupfer SGR Manual Del Usuario

Introduction

Orientation of the Appliance

Term
Porcelain Standard
Protection class
Qualified person,
qualified personnel
Schuko®
Specialist
suitable for washing devices
Verify, test
VESKA standard
1.5 Orientation of the Appliance
The front
"Front" refers to the side where members of the staff place trays (beginning of the belt).
The rear
"Rear" refers to the side where trays are taken from the belt. The controls of the conveyor system are fitted
here (end of the belt).
The right
"Right" refers to the right side of the conveyor system in relation to the conveying direction.
The left
"Left" refers to the left side of the conveyor system in relation to the conveying direction.
4330053_A7
Definition
Porcelain Standard is a measurement system for porcelain plates devised by
®
HUPFER .
The basic size of Porcelain Standard (PN) 1/1 is 8.7 x 6.3'' (220x160 mm) (1/2 PN
conforms to 4.3x6.3'' (110x160 mm), 1/4 PN conforms to 6.3x3.1'' (160x80 mm)). The
fitting lids have the following dimensions: 1/1 PN 9x6.6'' (228x168mm), 1/2 PN
4.4x6.3'' (111x161mm), 1/4 PN 4.4x3.2'' (111x81mm).
0 ¯
I
II
III
Qualified personnel are persons who due to their professional training, experience,
instruction and their knowledge of relevant standards, guidelines, accident prevention
regulations and operating conditions have been authorised by a person responsible
for system safety to carry out required activities and can recognise and prevent any
potential hazards (definition of specialists according to IEC 364).
The abbreviation of the German term "Protective contact" indicates a system of
domestic plugs and sockets equipped with protective earthed contacts used in most of
Europe.
A specialist is a person who can assess work assigned and can recognise possible
hazards themselves based on their professional training, skills, experience and
knowledge of the respective guidelines.
The appliance is suitable for cleaning in an automated cleaning system without
restrictions. Following agreement with the manufacturer the cleaning system must
achieve a hygienic, constant cleaning and drying result, which is to be approved by a
third party (client).
The exterior and interior housing are manufactured to a standard guaranteeing
hermetic sealing. It is not possible for water jets to ingress into hollow spaces in the
appliance. Installed electrical components and electrical wiring are protected by
appropriate sealing against any form of penetration by water. Protection class IPX6
(powerful pressurised water) to DIN EN 60529 (VDE 0470) is guaranteed. No water
remains or is carried over following the drying process.
Compare with certain values such as weight, torque, content or temperature.
Trays as per the VESKA standard are items used for distributing food in hospitals,
principally in Switzerland; they measure 20.9x14.8" (530x375 mm)
Section 1
Page 7
Belt Conveyor System
SGR | SPV