Safety Instructions For Maintenance And Care; Safety Instructions Regarding Fault Repair - Hupfer SGR Manual Del Usuario

Section 2
Page 12
2.7

Safety Instructions for Maintenance and Care

The following points shall be observed when carrying out any maintenance operations:
§
Take the conveyor system out of operation, switch it off and secure against unauthorised reactivation
before performing maintenance or troubleshooting operations. The appliance must be switched off at the
mains and secured against reactivation when working on the electrical system.
§
Only persons with qualifications and knowledge of electrical engineering may perform maintenance and
repair work on electrical devices.
§
If maintenance or repair work at live parts is required, a second person must be involved at all times.
§
The maintenance and care intervals specified in the operating instructions must be observed.
§
Before proceeding with maintenance and repair work close the maintenance area and the access to the
working area for unauthorised persons. If necessary, place an indication sign that draws attention to the
running maintenance and repair work.
§
Observe the valid product safety regulations for the product when handling oils, greases and other
chemical substances.
§
Lubricants must be compatible with foodstuffs such as edible oil.
§
Carry out all the checks and inspections of the appliance on a regular basis. Remove immediately
deficiencies, such as loose screw connections or melted cables.
§
Fit the dismantled safety devices back to the appliance and check them for proper functionality after
completing maintenance and repair work.
§
Cleaning instructions must be strictly observed for reasons of hygiene.
§
Never clean the running conveyor system.
§
Do not clean the conveyor system with steam-jet or high-pressure cleaners.
§
Take the conveyor system out of operation and switch it off at the mains in any area where steam-jet or
high-pressure cleaners are to be used.
2.8

Safety Instructions Regarding Fault Repair

The following aspects must be taken into account when carrying out any troubleshooting work:
§
The local Accident Prevention Regulations in force must be observed.
§
Take the conveyor system out of operation, switch it off and secure against unauthorised reactivation
before performing maintenance or troubleshooting operations. The appliance must be switched off at the
mains and secured against reactivation when working on the electrical system.
§
Observe the valid product safety regulations for the product when handling oils, greases and other
chemical substances.
§
Wear suitable protective clothing when carrying out any repair work.
§
Only authorised specialists may repair any faults or malfunctions.
§
Tighten the loosened screw connections and fit the safety devices back to the appliance if dismantled,
and test their proper functioning after completing the repair work.
§
Defective components may be replaced with original parts only.
Belt Conveyor System
SGR | SPV
Safety Instructions
Safety Instructions for Maintenance and Care
4330053_A7