Safety Instructions; Introduction; Symbols Used - Hupfer SGR Manual Del Usuario

Safety Instructions

Introduction

2 Safety Instructions
2.1 Introduction
The Safety Instructions section describes the risks associated with the appliance in terms of product liability
(according to the EU Machinery Directive).
The safety instructions are meant to warn of hazards and help to avoid damage to persons, the environment
and property. Please make sure that you have read and understood all the safety instructions given in this
section.
The valid national and international Safety at Work Regulations must be complied with. The manufacturer is
responsible for the valid regulations he/she has to provide. He/she must acquaint himself/herself and the
operator with the new regulations.
2.2

Symbols Used

Symbols are used in these operating instructions to indicate the dangers that may occur while operating or
cleaning the appliance. In both cases, the symbol provides information on the type and circumstances of
hazards.
The following symbols may be used:
4330053_A7
General hazard area
Hazardous electrical voltage
Risk of hand injuries caused by belt drive
Risk of hand injuries
Risk of crushing
Hazard caused by hot surfaces
Switching prohibited
Wear hand protection
Read and observe the operating instructions
Section 2
Page 9
Belt Conveyor System
SGR | SPV