Safety Instructions For Appliance Safety; Special Safety Instructions For Mobile Conveyor Systems - Hupfer SGR Manual Del Usuario

Section 2
Page 10
2.3

Safety Instructions for Appliance Safety

The appliance is operated safely if it is used correctly and carefully. Negligent handling of the appliance can
lead to a threat to life and physical well-being for the user and / or third parties as well as hazards for the
appliance itself and the operator's other property.
The following points are to be observed to ensure the appliance safety:
§
The appliance may only be operated as intended, when it is in perfect condition with regards to technical
standards, with awareness of safety and hazards and in accordance with the operating instructions.
§
All operating and actuating elements must be in a perfect and fail-safe condition with regards to technical
standards.
§
Only operate the conveyor system when all safety devices or emergency stop devices are available and
function properly. Easy access to the emergency stop button needs to be ensured. Never remove safety
devices.
§
Comply with the safety instructions and hazard warnings on the conveyor system and make sure they
are easy-to-read.
§
Before putting the appliance into operation, the appliance must be checked for external visible damage
and defects. In case of damage, immediately inform the competent bodies and switch off the conveyor
system.
§
Modifications or retrofits to the equipment are only permitted after consultation with the manufacturer
and upon receipt of their consent in writing.
§
Stationary conveyor systems are designed for permanent installation.
2.3.1

Special Safety Instructions for Mobile Conveyor Systems

§
The conveyor systems are designed for transport by hand only. It is not permitted to use a machine of
any type to move the appliance.
§
Conveyor systems can start moving on their own and randomly if the total locks are not applied.
§
Switch off the conveyor system and pull out the mains plug before transporting it.
§
Never pull the mains plug out of the socket by the wire.
§
Before moving the conveyor system, release the locking brakes. Moving the appliance with the applied
locking brakes can damage the chassis!
§
Do not move the appliance over inclined surfaces or stairs. When approaching walls and moving round
obstacles always pay attention to persons in the way.
§
When transporting the conveyor system, do not move it faster than a walking pace. It is difficult to brake
and steer heavily laden appliances. If necessary, ask for assistance when transporting the appliance.
§
When moving the conveyor system, make sure that the appliance will not tip over due to outside
influences or inattention. If, nevertheless, it tips over never try to catch the conveyor system.
§
Secure the conveyor system against rolling away by applying the total locks before putting it into
operation.
§
Do not place the appliance on sloping floors. Before placing the appliance in position make sure that the
floors are level and even and the conveyor system is level.
§
A maximum belt length of 7 m may not be exceeded.
Belt Conveyor System
SGR | SPV
Safety Instructions
Safety Instructions for Appliance Safety
4330053_A7