Measures At The End Of Use - Hupfer SGR Manual Del Usuario

Section 5
Page 28
5.2 Operation
CAUTION
Place the trays on the belt uniformly to ensure a smooth transport.
The conveyor system keeps on running automatically. If necessary, you can manually intervene in the
conveying process via the operating console.
Switching on:
§
Set the main switch (1) on the SGR from the switch position 0 to the switch position 1. The system is
switched on and ready for operation.
§
Set the belt speed on the potentiometer (4) to the value 1-2.
§
Press the green start button (3) or the foot switch (option) to start the conveyor system.
Switching off / stop:
§
The belt of the conveyor system will automatically stop moving if the light barrier has been interrupted.
§
Press the red stop button (2) or the foot switch (option) to stop the conveyor system, if required.
§
Set the main switch (1) on the SGR from the switch position 1 to the switch position 0. As a result, the
conveyor system will switch off.
5.3

Measures at the End of Use

CAUTION
To take the conveying device out of operation, proceed as follows:
§
Make sure that no more trays are placed onto the conveying device and that the conveyor belt is cleared
up.
§
Switch off the conveyor system on the control panel.
§
Disconnect the conveyor system from the mains with the main switch.
Belt Conveyor System
SGR | SPV
Rotating machine parts
Avoid any direct contact with the running conveyor belt and the outlet, feeding
and deflection points during operation or when performing any other work.
There is an indirect risk of injuries of the fingers caused by being pulled into
the appliance and crushing.
Never reach into the hazardous area of the conveyor system during operation.
Before switching on the conveyor system, make sure there is no risk of
reactivation of the belt.
Ensure that your fingers do not get caught under the belt when performing
work at the conveyor system.
Do not wear any loose-fitting clothing, such as scarves or ties, during
operations.
Rotating machine parts
Avoid any direct contact with the running conveyor belt and the outlet, feeding
and deflection points during operation or when performing any other work.
There is an indirect risk of injuries of the fingers caused by being pulled into
the appliance and crushing.
Never reach into the hazardous area of the conveyor system during operation.
Wait until the belt comes to a standstill.
Operation
Operation
4330053_A7