Care And Maintenance; Safety Measures; Hygiene Measures; Notes On Care And Maintenance Measures - Hupfer SGR Manual Del Usuario

Care and Maintenance

Safety Measures

7 Care and Maintenance
7.1 Safety Measures
DANGER
CAUTION
CAUTION
7.2

Hygiene Measures

It is essential for operating staff to act in the correct manner to ensure optimal hygiene.
Everyone must be informed about local applicable hygiene regulations, observe them and comply with them.
Use a waterproof plaster to cover wounds on hands and arms.
Never sneeze or cough on clean trays or crockery items.
7.3

Notes on Care and Maintenance Measures

CAUTION
Never clean the running conveyor system.
Do not clean the conveyor system with steam-jet or high-pressure cleaners.
Take the conveyor system out of operation and switch it off at the mains in any area where steam-jet or high-
pressure cleaners are to be used.
Dry well the conveyor system after the wet and moist cleaning to avoid the development of mould and
growth of germs and bacteria.
Let the belt dry well after cleaning.
The use of degreasing, chlorine-free agents (e.g. soapy water used normally in kitchens) and cleaning cloth
is sufficient for cleaning. PVC surfaces are never to be cleaned with solvents and aggressive substances.
4330053_A7
Hazardous electrical voltage
Electrical current can pose a considerable threat to life and physical well-
being and may lead to injuries.
Before performing cleaning and maintenance work, take the conveyor system
out of operation and secure it against unauthorised reactivation.
Rotating machine parts
There is a risk of injury caused by being pulled into the appliance and
crushing.
Before performing cleaning and maintenance work, take the conveyor system
out of operation and secure it against unauthorised reactivation. Avoid direct
contact with the running belt and the outlet, feeding and deflection points.
Never reach into the hazardous area of the conveyor system.
Risk of damages to property
Due to defective maintenance there is a risk of injury and equipment damage.
Meet the maintenance intervals and the specified deadlines for regular checks
and inspections.
Appliance damage
Never use chloride-containing cleaning agents, abrasive cleaning powder or
steel wool to clean the controls. Aggressive cleaning agents can destroy
plastics and scratch the display.
Use lukewarm water and a soft cloth to clean the control panel.
Section 7
Page 31
Belt Conveyor System
SGR | SPV