Set Up; Setting The Clock - Cuisinart AMW-60 Manual De Instrucciones

SET UP

1. Select a level surface with a minimum clearance of 12 inches (30cm)
above the oven, at least 3 inches (8cm) between the oven and any
adjacent walls with one side open.
NOTE:
° Blocking the intake and/or outlet openings can damage
the oven.
° Objects should not be stored on the top of the oven. If they are,
remove all objects before you turn on your oven. The exterior walls
can get hot when in use.
WARNING: DO NOT INSTALL THIS OVEN OVER A RANGE
COOKTOP OR OTHER HEAT-PRODUCING APPLIANCE.
IF IMPROPERLY INSTALLED NEAR OR OVER A HEAT SOURCE,
THE OVEN COULD BE DAMAGED AND THE WARRANTY
WOULD BE VOID.
3.0 inches
(8 cm)
3.0 inches
(8 cm)
12.0 inches
(30 cm)
Open
2. Remove any protective film from oven.
IMPORTANT: DO NOT REMOVE THE MICA COVER MICROGUIDE
ATTACHED TO INTERIOR. IT SHIELDS AND PROTECTS WAVE
ACTION.
3. Install turntable by setting ring assembly onto the oven floor,
centered over the turntable shaft. Then place glass tray into the oven,
carefully fitting the tray hub onto the turntable shaft.
Turntable
Ring
NOTE: Turntable assembly should always be in place during use.
Make sure glass tray is never used upside down. Tray must be properly
connected to the turntable ring before operating. If glass tray or
turntable ring assembly breaks, do not use. Contact consumer service.
4. Plug oven into a standard household outlet, making sure the voltage
and frequency are the same as those on the rating label.

SETTING THE CLOCK

The clock can be set when the oven is not cooking and the time (or 0:00)
is displayed on the screen.
To set the clock:
1. Press and hold the selector dial until
flashes.
2. Turn the dial to set hour, then press selector dial to confirm setting.
Minutes will flash.
3. Turn the dial to set minutes, then press selector dial to confirm setting.
8
Hub
Glass Tray
displays and the clock hour