Transportation And Storage; Inspect The Delivery; Inspect The Unit; Transportation Guidelines - Lowara ESH Serie Manual De Instalación, Funcionamiento Y Mantenimiento

en - Original instructions
Xylem Service Italia S.r.l., with headquarters in Via
Vittorio Lombardi 14 - 36075 Montecchio Maggiore
VI - Italy, hereby declares that the product:
Pump (see label on first page)
fulfills the relevant provisions of the following Euro-
pean directives:
• Machinery 2006/42/EC (ANNEX II - natural or le-
gal person authorised to compile the technical
file: Xylem Service Italia S.r.l.)
• Eco-design 2009/125/EC, Regulation (EC) No
547/2012 (Water pump) if MEI marked
and the following technical standards
• EN ISO 12100:2010, EN 809:1998+A1:2009, EN
60204–1:2006+A1:2009
• EN 60034–30:2009, EN 60034–30–1:2014
Montecchio Maggiore, 11.03.2016
Amedeo Valente
(Director of Engineering and
R&D)
rev.01
Lowara is a trademark of Xylem Inc. or one of its
subsidiaries.

2 Transportation and Storage

2.1 Inspect the delivery

1. Check the outside of the package for evident
signs of damage.
2. Notify our distributor within eight days of the de-
livery date, if the product bears visible signs of
damage.
Unpack the unit
1. Follow applicable step:
– If the unit is packed in a carton, then remove
the staples and open the carton.
– If the unit is packed in a wooden crate, then
open the cover while paying attention to the
nails and straps.
2. Remove the securing screws or the straps from
the wooden base.

2.1.1 Inspect the unit

1. Remove packing materials from the product.
Dispose of all packing materials in accordance
with local regulations.
2. Inspect the product to determine if any parts
have been damaged or are missing.
3. If applicable, unfasten the product by removing
any screws, bolts, or straps.
16
For your personal safety, be careful when you
handle nails and straps.
4. Contact the local sales representative if there is
any issue.

2.2 Transportation guidelines

Precautions
WARNING:
• Observe accident prevention regula-
tions in force.
• Crush hazard. The unit and the com-
ponents can be heavy. Use proper
lifting methods and wear steel-toed
shoes at all times.
Check the gross weight that is indicated on the
package in order to select proper lifting equipment.
Position and fastening
The pump or pump unit can be transported only hori-
zontally. Make sure that the pump or pump unit is
securely fastened during transportation and cannot
roll or fall over.
WARNING:
Do not use eyebolts screwed on the mo-
tor for handling the whole electric pump
unit.
Do not use the shaft end of the pump or
of the motor to handle the pump, the mo-
tor or the unit.
• Eyebolts screwed onto the motor may be exclu-
sively used to handle the individual motor or, in
case of a not balanced distribution of weights, to
partially lift the unit vertically starting from a hori-
zontal displacement.
Pump unit must always be fixed and transported as
shown in Figure 5 on page 370, and the pump with-
out motor must be fixed and transported as shown in
Figure 6 on page 370, Figure 7
Figure 8 on page 370.
Unit without motor
WARNING:
According to Machinery directive
2006/42/EC, a pump and motor that are
purchased separately and then coupled
together result in a new machine. The
person making the coupling is responsi-
ble for all safety aspects of the combined
unit and for CE-marking.

2.3 Storage guidelines

Storage location
The product must be stored in a covered and dry lo-
cation free from heat, dirt, and vibrations.
NOTICE:
Protect the product against humidity, heat sources,
and mechanical damage.
NOTICE:
Do not place heavy weights on the packed product.
on page 370, and