Introduction; A Charging The Hand Blender - Cuisinart CSB300BE Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 86

2. INTRODUCTION

Congratulations on your purchase of a new Cuisinart 3 in 1 cordless hand blender.
For over 30 years Cuisinart's aim has been to produce the very fi nest kitchen equipment. All Cuisinart
products are engineered for exceptionally long life, and designed to be easy to use as well as to give
excellent performance day after day.
To learn more about our products and for recipe ideas visit our website www.cuisinart.eu
3. PRODUCT CONTROL GUIDE
(refer to cover)
1. Safety lock/unlock button
2. Battery power indicator light
3. Blue speed indicator lights
4. Speed control switch
5. On/Off power button
6. Power handle / main unit
7. Charging stand
8. Blending shaft
9. Protective blade guard
10. Potato masher gearbox
11. Potato masher attachment
12. Whisk gearbox
13. Whisk attachment
4. INSTRUCTIONS FOR USE
Before fi rst use, we recommend that you wipe the main unit with a clean, damp cloth to remove any
dirt or dust. Dry it thoroughly with a soft absorbent cloth. Carefully clean all the attachments (except
for the charging base, whisk gearbox and potato masher gearbox) in warm soapy water.
N.B. Do not use abrasive cleaners, hard implements or a scourer. Take care when handling the
blending shaft as the blades are very sharp.
A. CHARGING THE HAND BLENDER
The batteries in your hand blender have not been fully charged. Before using, the batteries must
be charged until the blue battery indicator light illuminates. With a full charge, your hand blender
will run for approximately 20 minutes, depending on use. Your hand blender will be fully charged in
approximately 2-2.5 hours.
N.B.To charge the main unit, insert the adapter plug into a mains supply outlet and insert the ead
into the charging port located on the back of the charging stand. Place the unit in the stand and
ensure the charging port on the unit connects with the protruding contact pin on the inside of the
stand. Alternatively, you may also insert the lead directly into the charging port located at the back
of the main unit without using the charging stand.
20

Publicidad

Tabla de contenido
loading

Tabla de contenido