GreenWorks Tools 2600807 Manual De Utilización página 10

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
MAINTENANCE
WARNING
All service and all maintenance checks must be carried
out on a stationary machine with the motor switched off.
Before any maintenance operation, switch off the mo-
tor.
WARNING
Wear adequate clothing, gloves and goggles before car-
rying out any maintenance.
REPLACING THE SCRAPER (FIG.5 -6)
WARNING
IN ORDER TO AVOID SERIOUS PERSONAL INJURY,
TURN THE SNOW SHOVEL OFF AND UNPLUG IT
BEFORE PERFORMING ANY MAINTENANCE.
Use only the manufacturer's original replacement parts.
„ Place the snow shovel on the ground or on a work
bench. Position the snow shovel so that the impeller
is facing up.
„ Remove the four screws (13) that are located beneath
the impeller that secure the scraper to the housing
using a phillips screwdriver.
„ Remove the scraper (6), and discard it in the proper
manner.
„ Snap the new scraper into position, and attach it to the
snow shovel by reinstalling the four screws.
English (original instructions)
5
REPLACING THE IMPELLOR 6HH ¿JXUH 
Remove the right side cover by removing 6 screws.
①.
Pull the belt tensioner (idler arm) away from the drive
②.
pulley. Be sure not to lose the washer, spring and
screw left.
Remove the belt.
③.
Remove the 4 screws.
④.
Remove the left side cover by removing 6 screws.
⑤.
Remove the nut that secures the left side plate.
⑥.
Remove the impellor shaft with pulley assembly
⑦.
attached.
Withdraw the old/damaged impellor. Be sure not to
⑧.
loose the shaft sleeve that secures left side of the
shaft.
Insert the impellor shaft with pulley assembly attached
⑨.
in the new impellor. Be sure to replace the retained
shaft sleeve that secures left side of the shaft.
Replace and tighten the remaining nut to secure the
10
⑨.
left side plate assembly.
Replace and tighten the remaining screws to secure
11
⑨.
the left side cover.
Replace and tighten the remaining screws to secure
⑨. 12
the pulley assembly.
Place the belt back into its place.
13
⑨.
14
⑨. Place the belt tensioner (idler arm) back into its place.
15 Replace and tighten the remaining screws to secure
⑨.
the right side cover.
STORAGE
„ Allow the motor to cool down before storing.
„ Store the snow shovel in a locked location in order to
prevent unauthorized use or damage.
„ Store the snow shovel in a dry, well-ventilated area.
„ Store the snow shovel out of the reach of children.
CLEANING
,Q RUGHU WR DYRLG VHULRXV SHUVRQDO LQMXU\ WXUQ WKH VQRZ
shovel off and remove battery before cleaning or servic-
ing.
Use a small brush to clean the outside of the snow
shovel. Do not use strong detergents.
Household cleaners that contain aromatic oils such as
pine and lemon, and solvents such as kerosene can
damage the plastic housing and handles. Wipe off any
moisture using a soft cloth.