Preparing The Crankset - Look ZED 3 Manual Del Usuario

Preparing the left nut
[ A ]
Nut
Expanding ring
Lubricate the contact surfaces
between the nut and expanding
ring. Position the slit in the expan-
ding ring opposite the slit in the
nut.

Preparing the crankset

[ A ] [ B ]
Lubricate:
• The right ring
• The expanding ring
• The carbon bearing
seat (on the right)
C
Do not lubricate the
threads (on the carbon
or the right ring).
C
Fit the right ring and the
D expanding ring to the left
crank.
D
COUPE C-C
ECHELLE 1 : 2
C
G
C
COUPE C-C
PREPARING THE CRANKSET
[ B ]
B
Screw M3x20
Torque 1Nm
Add some thread
lock type Loctite
243
COUPE A-A
ECHELLE 1 : 1
Assemble the expanding ring
with the nut, ensuring that the
ring is correctly fitted in its
housing.
[ C ]
Pass the right ring over
the right bearing seat in
the crankset, ensuring
that the slit in the ring is
in the lower position.
C
D
C
G
A
A
[ D ]
Turn the ring to the right
until the slit is in the up-
per position.
DÉTAIL D
ECHELLE 5 : 1
Expanding ring Right ring
DÉTAIL D
ECHELLE 5 : 1
ZED 3
OK
crankset
DÉTAIL H
ECHELLE 5 : 1
DÉTAIL H
[ C ]
Nut
Expanding
ring
OK
DÉTAIL B
ECHELLE 5 : 1
Check that the ring is correctly
fitted in the right direction with its
flange against the nut.
[ E ]
Assemble the expanding
ring over the right ring,
ensuring that the latter
is fitted in the correct
direction.
DÉTAIL D
ECHELLE 5 : 1
Attention: the slit in the
expanding ring must be
opposite the slit in the
right ring.
NOK
DÉTAIL H
ECHELLE 5 : 1
EN
Fig 9
NOK
DÉTAIL F
ECHELLE 5 : 1
[ F ]
35