Fitting The Crankset - Look ZED 3 Manual Del Usuario

EN
[ A ]
Once the crankset has been prepared. Fit it into the
frame with the left crank.
[ C ]
Slide the nut with the left crank.
[ E ]
Insert the 2.5mm Allen key into the hole opposite the
locking screw and use it to turn and tighten the nut.
Tighten the nut until you no longer feel any play in the
assembly. (Use the cranks to check the play).
36

FITTING THE CRANKSET

[ B ]
Keep passing the crankset through the frame, taking
care not to scratch the crankset with the bearings or
the frame with the chainrings.
[ D ]
Prime the nut to be screwed.
[ F ]
Once the crankset is correctly mounted, tighten the
M3 screw to 1Nm having previously added some
thread lock type Loctite® 243.
Check that there is no play in the crankset. If there
is, unscrew the M3 screw and re-tighten the Zed nut.
Fig 10
Attention :
Tighten to = 1Nm
With Loctite® 243