Look KEO BLADE Manual De Instrucciones página 15

PRODUCT CONTENTS AND COMPONENTS
Congratulations on your purchase of a pair of LOOK KEO pedals.
Within the packaging of your pedals you will find the following components:
1 pair of pedals – 1 pair of KEO GRIP cleats – 6 fixing screws – 6 rectangular washers – 1 assembly
notice – 1 LOOK sticker
MOUNTING THE PEDALS
Ensure that the threads of the cranks are BSA (9/16x20).
Clean and grease the crank pedal threads prior to mounting the pedals.
WARNING: there is each a right pedal and a left pedal. The left pedal, marked with a ring on the
axle, threads counter-clockwise into the left crankarm. Tighten the pedal using an 8 mm Allen key (Hex
key) for pedals equipped with steel axles and using a 6 mm Allen key (Hex key) for pedals equipped
with a titanium axle. In either case using the Allen key, screwing takes place from the backside of the
crank. The recommended torque is 40Nm (29.5 lbf-ft).
26
Q-FACTOR ADJUSTMENT
With the latest generation axles, LOOK provides
the consumer with the possibility to increase the
Q-factor.
Using washers that you may place between the
pedal and the crank, the user has the possibility
to increase the distance between the two pedals.
These washers are available from you local
accredited LOOK reseller.
27