Bahco START & STOP Manual De Instrucciones página 4

English
START-STOP BATTERY TEST
1. Press the key to select START STOP.
In this stage, you will find 3 tests for selection.
START STOP
BATTERY TEST
SYSTEM TEST
2. Press the ◄ ► key to select battery type:
a. EFB (ENHANCED FLOODED)
b. AGM FLAT PLATE
Press «ENTER» to confirm choice.
3. Press the ◄ ► key to select battery rating:
SAE, CA, EN, IEC or DIN. Press «ENTER»
to confirm choice.
4. Press the ◄ ► key to input the battery capacity:
SAE (CCA): 40~2,000
EN: 40~2,100
DIN: 25~1,300
IEC: 30~1,500
CA (MCA): 50~2,500
Press «ENTER» to begin test.
5. Press the ◄ ► key to confirm the position of
the battery if the surface charge is detected.
Follow the tester 's steps to remove the surface
charge if it happens.
6. Testing battery.
1. START STOP
BATTERY TYPE
EFB
SELECT RATING
SAE
SET CAPACITY
XXXX SAE
TEST IN VEHICLE?
TESTING
6
- 5 -
7. When test is completed, the display shows the results as following
{Press the key to select: SOH (STATE OF HEALTH) or
SOC (STATE OF CHARGE)}.
GOOD & PASS
The battery is good & capable of holding a charge.
GOOD & RECHARGE
The battery is good but needs to be recharged.
RECHARGE & RETEST
Battery is discharged. The battery condition
cannot be determined until it is fully charged.
Recharge & retest the battery.
BAD & REPLACE
The battery will not hold a charge. It should be
replaced immediately.
BAD CELL & REPLACE
The battery has at least one cell short circuit. It
should be replaced immediately.
NO
English
GOOD & PASS
XX.XXV XXXXSAE
SOH: XXXXSAE
XXX%
SOH: XXXXSAE
XXX%
GOOD & RECHARGE
XX.XXV XXXXSAE
SOH: XXXXSAE
XXX%
SOH: XXXXSAE
XXX%
RECHARGE & RETEST
XX.XXV XXXXSAE
SOH: XXXXSAE
XXX%
SOH: XXXXSAE
XXX%
BAD & REPLACE
XX.XXV XXXXSAE
SOH: XXXXSAE
XXX%
SOH: XXXXSAE
XXX%
BAD CELL & REPLACE
XX.XXV XXXXSAE
SOH: XXXXSAE
XXX%
SOH: XXXXSAE
XXX%
7
- 6 -