Bahco START & STOP Manual De Instrucciones página 6

English
NOTE that there might be some messages displayed to different
circumstances as below.
LOAD ERROR
The tested battery is bigger than 2000SAE (CCA).
Or the connection is not properly established. Check the capacity of
the battery & make sure the clamp lead is properly connected.
LOAD ERROR
10
- 9 -
SYSTEM TEST
1. Press «ENTER» button, you will view the
following screen.
2. Turn off all vehicle accessory loads such as
lights, air conditioning, radio, etc. before starting
the engine.
3. When the engine is started, one of the three results will be
displayed along with the actual reading measured.
CRANKING VOLTS NORMAL
The system is showing normal draw. Press
«ENTER» to perform the charging system test.
CRANKING VOLTS LOW
The cranking voltage is below normal limits,
troubleshoot the starter with manufacturers
recommended procedure.
CRANKING VOLTS NO DETECTED
The cranking voltage is not detected.
4. If the cranking voltage is normal, press
«ENTER» to begin charging system test.
5. Press the «ENTER» key, you will view
the following screen.
English
3. SYSTEM TEST
TURN OFF LOADS
START ENGINE
CRANKING VOLTS
XX.XXV NORMAL
CRANKING VOLTS
XX.XXV
CRANKING VOLTS
NO DETECTED
PRESS ENTER FOR
= CHARGING TEST =
MAKE SURE ALL
LOADS ARE OFF
11
- 10 -
LOW