Tabla de contenido
Publicidad
and the type of packaging to make sure they are suitable for correct storage.
NOTE:
PROTECTIVE TREATMENT
1. Check that engine oil and coolant levels are up to the maximum.
3. Run engine at idle speed for 15 minutes.
4. Switch off engine.
5. Drain oil.
7. Start engine and check for fuel and oil leaks.
8. Bring the engine to ¾ of maximum speed for 5-10 minutes.
9. Switch off engine.
13. Cover all openings to prevent dust or debris from entering engine.
14. Thoroughly clean all external parts of the engine.
NOTE:
NOTE:
ENGINE STORAGE
PREPARING THE ENGINE FOR OPERATION AFTER PROTECTIVE TREATMENT
1. Remove the protective sheeting.
2. Remove any areas covered to keep dust and debris out.
3. Use a cloth soaked in degreaser to remove applied protective coating.
4. Remove intake manifold.
9. Start engine and run at ¾ of maximum speed for 5-10 minutes.
10. Switch off engine.
11. Remove protective oil to replace with engine oil.
NOTE:
NOTE:
3
79
Publicidad
Tabla de contenido
