Overview; General; Technical Parameters; Working Environment Requirements - SATA AE1016H Instrucciones De Uso

7.1 Overview

7.1.1 General

The right auxiliary arm is a high-grade accessory of tire changer independently developed by the company and applies to the removal and
installation of the common tires of a diameter of 11"- 26" and the wide, flat and hard tires. It is featured by the follows:
- Wide scope It applies to not only the various models of tire changer produced by our company and also the models with similar fitting
conditions from the industry.
- With the excellent process performance, it may be used in conjunction with various accessories to remove and install the wide, flat and
hard tires.
- Easy and flexible operation. Accurate positioning. Efficient removal and installation of tire

7.1.2 Technical Parameters

Basic size of equipment
Height (mm)
1200

7.1.3 Working environment requirements

Working temperature 0° C ~ 45° C
The site and installation location shall meet the safety requirements. The machine shall be connected to the compressed air system
according to the Instruction and well ventilated with 0.5 m -1 m clearance around to make all parts work properly without limitation. If the
machine is installed outdoors, the protective shed shall be provided to protect it from the rain and sun.
68
AE1016H/AE1016H-3
Length (mm)
Max.1600
Relative humidity 30 ~ 95%
中文
EN
- Air source working pressure at air inlet: 8 - 10 bar.
- Rated working pressure: 8 bar
- Turning radius of roller bracket (working arm): 677 mm
- The distance between the center of rotating axis and the
edge of tire changer: 180 mm
- Height adjustment range of working arm: 365 mm
Width (mm)
Max.1410
DE RU KO PT JA
Net weight (1 kg)
70
ES