DANGER: The petrol is flammable and explosive .so when you outlet the fuel ,please do not smoke and close to the fire .and please operate
this outside ventilated and dry up the petrol outside.
(3) Take off spark plug, inject a little lubricant (15 to 20ml) into cylinder. Turn off ignition switch, operate kick start pedal several times, let machine
oil spread proportionally in the cylinder, and then install spark plug.
(4) Rinse and lubricate driven chain completely.
(5) Lubricate all the control cable
(6) When stored in wet or saline atmosphere, all the outside metal of motorcycle shall be covered with a anti-rust oil. Do not put machine oil on
any rubber part or seat.
(7) Take off battery, store it in ventilating, dry, shady and cool place. Charge it per month.
(8) Blow tyre to regulated pressure.
(9) Put plastic bag on muffler outlet, and enlace it tightly to avoid wet air going into it.
(10) Use ventilating material to cover motorcycle, and store it in dry and ventilating place with little temperature difference. Put the motorcycle
on the wooden board, let the front and rear tyre leave the ground.
Motorcycle usage after storage
Take off the motorcycle cover, and clean the motorcycle.
If storage period lasts for 4 months above, please change engine machine oil.
Check the battery voltage. If the voltage is below 12.3V, please charge it in low-speed condition, and then install battery.
Clean anti-rust lubricant in the tank, and add fuel.
Check the motorcycle according to "Pre-operation" Guidance, and ride the motorcycle in safe ground, make sure all the performances are OK.
42