Preparation
Preparation
Installing the Plasma Display
Over 50 cm
(19 11/16 inches)
Over
10 cm
(3 15/16
inches)
Location
• Avoid direct sunlight. Maintain adequate ventilation.
• The length of the system cable used to connect the Plasma
Display and the Media Receiver is about 3 m (9.8 feet).
• Because the Plasma Display is heavy, be sure to have
someone help you when moving it.
CAUTION
• If you place anything on the top of the Media Receiver, it will
not receive enough ventilation and will not operate properly.
NOTE
• Allow enough space around the upper and back parts when
installing to ensure adequate ventilation of the rear of the
unit.
Using the optional PIONEER stand
For details on installation, refer to the instruction manual
supplied with the stand.
CAUTION
• This product can be used only with the optional PDK-TS10
and PDK-FS06 stand. Using other stands can result in
instability, possibly causing injury.
Using the optional PIONEER speakers
For details on installation, refer to the instruction manual
supplied with the speaker.
CAUTION
Operating Environment
Operating environment temperature and humidity:
+0 °C to +40 °C (+32 °F to +104 °F), less than 85 %RH (cooling
vents not blocked) Do not install this unit in a poorly ventilated
area, or in locations exposed to high humidity or direct sunlight
(or strong artificial light)
Installing the Media Receiver
Plasma Display
System cable
(approx. 3 m/9.8 feet)
CAUTION
• Do not place a VCR or any other device on the top
of the Media Receiver.
• When installing, allow enough space on the sides
and above the Media Receiver.
• Do not block the side ventilation opening or the
rear exhaust opening of the Media Receiver.
REC
ON
STANDBY
TIMER
STANDBY/ON
Over 5 cm
(2 inches)
Ventilation
opening
CAUTION
Placing the Media Receiver in the vertical position can result in
product damage and malfunction.
Media Receiver
REC
ON
STANDBY
TIMER
STANDBY/ON
Over 5 cm
(2 inches)
PULL
OPEN
Over 5 cm
(2 inches)
Over 10 cm (3 15/16 inches)
Exhaust
opening
05
PULL
OPEN
17
En