Using Hdmi Input; Connecting Hdmi Equipment - Pioneer PDP-5060HD Manual De Instrucciones

Enjoying through External Equipment
12

Using HDMI Input

The INPUT 1 and INPUT 3 terminals include HDMI terminals to
which digital video and audio signals can be input. To use the
HDMI terminal, activate the terminal and specify the types of
video and audio signals to be received from the connected
equipment. For the types of these signals, see the operation
manual that came with the connected equipment.
Before starting the menu, press INPUT 1 (or INPUT 3) on the
remote control unit or press INPUT on the Media Receiver to
select INPUT 1 (or INPUT 3). For INPUT 3, HDMI has been
selected as the factory default.
Input signal correlation table
19201080i@59.94/60Hz
720480p@59.94/60Hz
1280720p@59.94/60Hz
720(1440)480i@59.94/60Hz
For audio, the system supports the following:
• Linear PCM (STEREO 2ch)
• Sampling frequency: 32 kHz, 44.1 kHz, 48 kHz
NOTE
• PC signals are not supported.

Connecting HDMI equipment

Media Receiver (rear view)
ANT/
CABLE A IN
MONITOR
OUT
INPUT 2
R-AUDIO-L VIDEO
ERVICE ONLY
INPUT 1
Audio cable
(commercially available)
Make this connection
when inputting analog
audio signals.
68
En
S400
G-LINK
(TS)
OPTICAL
Cable CARD
R-AUDIO-L DIGITAL OUT
SUB WOOFER
INPUT 3
Y C / P C / P
S-VIDEO B B R R
INPUT 1 INPUT 3 BLACK
COMPONENT
VIDEO SYSTE
HDMI
HDMI cable
(commercially
available)
HDMI equipment
To activate the HDMI terminal:
1
Press HOME MENU.
2
Select "Option". ( / then ENTER)
3
Select "HDMI Input". ( /
4
Select "Setting". ( / then ENTER)
5
Select "Enable". ( / then ENTER)
Item Description
Disable Deactivates the HDMI terminal.
(factory default)
Enable Activates the HDMI terminal.
6
Press HOME MENU to exit the menu.
To specify the type of digital video signals:
1
Press HOME MENU.
2
Select "Option". ( / then ENTER)
3
Select "HDMI Input". ( /
4
Select "Video". ( / then ENTER)
5
Select the type of digital video signals. ( /
• If you select "Auto", an attempt will be made to identify
the type of digital video signals when digital video
signals are received.
Item Description
Auto Automatically identifies input digital video signals.
(factory default)
Color-1 Digital Component Video signals (4:2:2) locked
Color-2 Digital Component Video signals (4:4:4) locked
Digital RGB signals locked
Color-3
6
Press HOME MENU to exit the menu.
NOTE
• If you select a parameter other than "Auto", make such a
setting that results in natural color.
• If no image appears, specify another digital video signal type.
• For the digital video signal types to be specified, check the
operation manual that came with the connected equipment.
To specify the type of audio signals:
1
Press HOME MENU.
2
Select "Option". ( / then ENTER)
3
Select "HDMI Input". ( /
4
Select "Audio". ( / then ENTER)
5
Select the type of audio signals. ( /
• If you select "Auto", an attempt will be made to identify
the type of audio signals when audio signals are
received.
then ENTER)
then ENTER)
then ENTER)
then ENTER)
then ENTER)