Angelo Po BX61GW Manual De Uso página 48

Code Fault
No water in chamber, or water
H2O
pressure too low
No water at drain, or water
H2O.
pressure too low
No mains gas, gas pressure too
E12
low or fl ame detection failure
Oven door opening or closure
OPE
request.
Indicates that cleaning is re-
CLE
quired
Indicates the need for the des-
dEC
caling operation.
The cooking chamber probe
E01 has failed or is not properly
connected
The product core probe is not
E02 inserted in the food or has
failed
The steam discharge probe
E03
has failed
The motor-operated valve is
E04
not positioned correctly
GB
E05 Safety thermostat failure
E06 Overload cutouts tripped
The optional vacuum probe
E08 has failed or is not properly
connected
Maximum
E09 temperature
exceeded
Electrical component com-
E10
partment has overheated
E11
Electronic circuit board dia-
E13
gnostics tripped
E14
3378750_ut_GB
Remedy
Check that mains water is pre-
sent or adjust the pressure (see
"installation manual"); if the
problem persists inform the af-
ter-sales service
Check that mains water is pre-
sent or adjust the pressure (see
"installer instructions"); if the
problem persists inform the af-
ter-sales service
Press reset button (the button
may have to be pressed several
times); if the problem persists in-
form the after-sales service
Open or close the oven door
Inform the after-sales service if
this message continues to be
displayed
Clean
Perform descaling
Inform the after-sales service
Check the position of the prod-
uct core probe or inform the af-
ter- sales service if it is faulty
Inform the after-sales service
Switch on the oven again and if
the problem persists inform the
after-sales service
Inform the after-sales service
Inform the after-sales service
Press the "Reset" button
allowed
in chamber Inform the after-sales service
The oven solves the problem
on its own
Inform the after-sales service
- 20 -
Notes
Convection cooking cycles can
still be carried out
Convection and steam cook-
ing cycles can still be carried
out.
Stop cooking if this message is
repeated more than once
The cooking cycle does not
start until the door has been
opened or closed as required
The oven's functions are ena-
bled so cooking cycles can be
carried out
The oven's functions are ena-
bled so cooking cycles can be
carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
Cooking cycles with product
core probe cannot be carried
out
Convection and steam cook-
ing cycles can still be carried
out
Convection and steam cook-
ing cycles can still be carried
out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
Disconnect and reconnect the
vacuum probe before starting
the cooking cycle.
If the problem persists, call the
after-sales service
The oven's functions are disa-
bled so no cooking cycles can
be carried out
The oven's functions are ena-
bled so cooking cycles can be
carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
ENGLISH