Producing The Electrical Connections Of The Trigger Electronics; Preparing The Eps - Bosch CAM 847 Manual De Instrucciones

en 30 | CAM 847 | Rotary encoder setting
7.2 Producing the electrical connections
of the trigger electronics
Procedure:
1. Connect the cable 1 684 465 388 to terminal X4 of
the trigger electronics.
2. Connect the power supply cable 1 684 463 504 to
terminal X2 of the trigger electronics.
3. Connect the power supply cable 1 684 463 503 to
terminal X1 of the trigger electronics.
4. Connect the cable 1 684 465 499 (rotary encoder
connecting cable) and cable 1 684 465 590 to termi-
nal X8 of the trigger electronics.
i
If you are using the VPM 844 tester set, the connec-
ting cable 1 684 465 499 may be connected to the
terminal unit A11 of the VPM 844 tester set. In this
case, unplug the connecting cable from the terminal
unit.
1
2
3
4
Fig. 21: Connection of trigger electronics
1 Power supply cable (+) 1 684 463 503
2 Power supply cable (-) 1 684 463 504
3 RS232 connecting cable 1 684 465 388
4 Connecting cable 1 684 465 499
5 Connecting cable 1 684 465 590
|
1 689 978 508 2011-12-03
5
7.3

Preparing the EPS

i
The following additional clamping parts are required
for adapting the CAMBox to the flywheel of the EPS:
Intermediate flange 1 685 700 140, coupling assem-
bly 1 686 401 024, protective hood 1 685 510 148
and guard ring 1 685 510 176.
Procedure:
1. Attach the intermediate flange 1 685 700 140 and
coupling assembly 1 686 401 024 to the flywheel of
the EPS.
2. Push the protective hood 1 685 510 148 onto the
clamping bracket and secure to the clamping bracket
of the EPS using the clamping screw.
3. Push the guard ring 1 685 510 176 onto the protecti-
ve hood as far as the stop.
Robert Bosch GmbH