Preassembling The Lubricating Oil Return Hose; Fitting The Edge Protector To The Kma; Affixing The Adhesive Labels - Bosch CAM 847 Manual De Instrucciones

3.6 Preassembling the lubricating oil
return hose
Procedure:
¶
Push the two hose manifolds (Fig. 12, Pos. 1) into
the transparent PVC hose (Fig. 12, Pos. 3) and secu-
re with the hose clamps (Fig. 12, Pos. 2).
1 2 3
Fig. 12: Return hose for lubricating oil
3.7 Fitting the edge protector to
the KMA
Procedure:
¶
Press the edge protector (Fig. 13, Pos. 1) onto the
edge of the oil pan of the KMA.
1
Fig. 13: Edge protector
Robert Bosch GmbH
3.8
i
Procedure:
2 1
1. Clean and grease the adhesive surfaces of the
2. Detach the adhesive labels (Fig. 14, Pos. 1) from the
458823_23pa
3. Detach the adhesive labels (Fig. 14, Pos. 4) from the
Fig. 14:
Structure | CAM 847 | 25

Affixing the adhesive labels

If you are using the CRI 846/CRI 846H tester set,
the adhesive labels are already affixed to the KMA
and the heat exchanger. In this case, please skip this
section.
heat exchanger and KMA with a suitable product
(e. g. spirit).
film and affix to the heat exchanger (Fig. 14, Pos. 2).
film and affix to the front cover of the KMA testing de-
vice (Fig. 14, Pos. 3).
1. 1 2. 1 2.2 3. 1 3.2 4. 1
1 2 3
1 2 3 4 5 6
DIESEL FUEL
KMA and heat exchanger
en
1
5.2 6.2
4.2
2
6
4 5
7 8 9 10 11 12
3
4
|
1 689 978 508 2011-12-03