GreenWorks Tools 2402707 Manual De Utilización página 2

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
SPECIFICATIONS
Type
Voltage
Frequency
Input Power
Air volume
Air Velocity
Weight
sound pressure level
sound power level
Vibration
DESCRIPTION See Figure 1.
1. Power/speed slide switch
2. Power cord
3. Cord retainer
4. Auxiliary handle
5. Lock button
6. Blower tube
7. Mulcher tube
8. Mulch/Vacuum gate
9. Shoulder strap
10. Bag
11. Notched area
12. Slot
13. Air outlet
14. Thumb screw
ASSEMBLY
UNPACKING
Carefully remove the product and any accessories
from the box.
Inspect the product carefully to make sure no
breakage or damage occurred during shipping.
Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product.
If any parts are damaged or missing, please call
your Greenworks Tools service centre for assistance.
The blower vac is supplied with some components not
assembled. To assemble these, proceed as follows:
English (original instructions)
2402707
220-240 V
50 Hz
2800 W
11-14 m³/min
270-320 km/h
4.5 Kg
92.1 dB(A) KpA:3
dB(A)
110 dB(A)
3.97 m/s , k= 1.5 m/s
2
ASSEMBLE AS A MULCHER
See figure 2.
Slide the front and rear mulcher tubes together
until locked. (See fig 2)
Loosen the thumb screw and open the mulching
gate. (See fig 2.1)
Hold the gate open. (See fig 2.2)
Insert the "wedged" end clip of the mulcher tube
into the rear clip. (See fig 2.2).
Fix the mulcher tube by tightening the thumb
screw. (See fig 2.3)
To remove mulcher tubes, follow the steps above
in reverse.
Insert the bag adaptor into the blower outlet. Lock
the bag adaptor with the lock button. To remove
the bag, simply press lock button and remove bag.
(see Fig.4).
NOTE: It may be necessary to remove the blower tube
or mulcher tubes to clear a blocked tube or impeller.
2
To prevent serious personal injury, make sure the
switch is in the OFF position, it is unplugged, and
the impellers have stopped before attaching or
removing tubes.
ASSEMBLE AS A BLOWER
See figure 3.
Slide blower tube forward until the notched areas
on the blower housing click into the slots on the
tube.
INSTALLING BAG WITH SHOULDER HARNESS
See figure 4.
While standing in the operating position adjust
the length to fit the operator's size. Pull the tab
lengthen , pull the strap to shoten.
CONNECTING THE POWER CORD See figure 5.
Secure the extension cord to the motor housing
using the cord retainer. This prevents accidental
removal of the electrical cord.
Plug the female end of the electrical cord into the
receptacle at the back of the unit.
OPEARTION
STARTING/STOPPING THE BLOWER/MULCHER
See figure 6.
To turn on, slide the power/speed slide switch. '1'
indicates the tool runs at slow speed, and '2' at
high speed.
To turn off, slide the switch to '0'.
IMPORTANT: While in mulching mode the blower
MUST be in high speed position.
1
WARNING