Roger Technology B70/1DC Manual De Instrucciones página 80

STEP MODE.
PARTIAL OPENING
OPENING
CLOSING.
STOP.
Courtesy light. The output COR is managed from the remote control. The light remains lit as long as the remote
control is active. The parameter
Courtesy light in step mode (PP). The output COR is managed from the remote control.
The remote control turns the courtesy light on and off. The parameter
(1)
command. Example: parameters
•
pressing CHB on the remote control. Press CHB to activate partial opening.
Selecting courtesy light mode
Disabled.
ACTIVE. The light remains lit for the entire duration of the manoeuvre.
From 3 to 90 s. The light remains lit for the time period set after the manoeuvre is completed.
From 2 to 9 minutes. The light remains lit for the time period set after the manoeuvre is completed.
When the clock function is active, the gate opens and remains open.
At the end of the programmed time set with the external device (clock), the gate closes.
When the clock function is active, the gate opens and remains open. Any command signal received is ignored.
When the clock function is active, the gate opens and remains open. Any command signal received is accepted.
When the gate returns to the completely open position, the clock function is reactivated.
Enable safeguarded gate closure/opening.
E
nabling this parameter ensures that the gate is not left open due to an incorrect and/or accidental command.
This function is NOT enabled if:
• the gate receives a STOP command;
•
the sensing edge intervenes, detecting an obstacle in the same direction in which the function is enabled.
If instead the sensing edge detects an obstacle during the movement opposite to the guaranteed one, the
function is maintained active.
• the number of closure attempts set by parameter
• the acquired position is lost (perform position recovery, see chapter 20).
Disabled. The parameter
Guaranteed closing enabled.
After a period of time set with parameter
regardless of the parameter
Guaranteed closing and opening enabled.
If the gate is closed as a result of a step mode command, after a period of time set with parameter
If the gate is stopped by the obstacle detection system during a closure manoeuvre, the gate closes after a period
of time set with parameter
If the gate is stopped by the obstacle detection system during an opening manoeuvre, the gate closes after a period
of time set with parameter
80
N.B.: With ROGER TECHNOLOGY plug-in radio receiver board.
N.B.: With ROGER TECHNOLOGY plug-in radio receiver board.
is ignored.
(1)
(1)
(1)
(1)
and set:
is not displayed.
, and then closes the gate.
.
.
is ignored.
has been reached;
, the control
), and then the gate closes.