General Safety Precautions - Roger Technology B70/1DC Manual De Instrucciones

1

General safety precautions

WARNING: IMPORTANT SAFETY INSTRUCTIONS
THESE INSTRUCTIONS MUST BE FOLLOWED TO GUARANTEE THE
Failure to observe the information included in this manual may result in
personal injury or damage to the equipment.
ROGER TECHNOLOGY cannot be held responsible for any damage or
injury due to improper use or any use other than the intended usage indicated
in this manual.
The installation, electrical connections and adjustments must be performed
with applicable regulations.
Read the instructions carefully before installing the product.
Incorrect installation may pose risks.
Before installing the product, make sure it is in perfect condition: In case
of doubts, do not use the product and refer exclusively to professionally
Do not install the product in explosive environment and atmosphere:
safety precautions and to the protection or segregation of areas involving
crushing, shearing, dragging risks or any other risks.
ROGER TECHNOLOGY is not liable for failure to observe the good practices
occur during use.
The safety devices (photocells, sensing edges, emergency stops, etc.) must
be installed taking into consideration the following: the regulations and
directives in force, the good practices criteria, the installation environment,
the operating logic of the system and the forces generated by the motorised
door or gate.
The safety devices must protect any areas where there is crushing, shearing,
dragging or any other danger in general generated by the motorised door or
gate; the installer is advised to check that the moving wings do not have
sharp edges or anything that may pose shearing and/or dragging risks.
If it is deemed necessary based on the risk analysis, install sensing edges
on the mobile part.
It should be noted that, as provided by the UNI EN 12635 standard, all
and, if necessary, also checked.
58
SAFETY OF THE PERSONS
PRESERVE THESE INSTRUCTIONS