Travel Acquisition; Before Starting - Roger Technology B70/1DC Manual De Instrucciones

11

Travel acquisition

For the system to function correctly, the barrier travel must be acquired by the controller.
11.1

Before starting:

IMPORTANT:
Select the automation system model installed with the parameter
KEY: HIGH SPEED Motors
SELECTION MODEL
BH30/600
BH30/800
BH30/500/HS
BH30/600/HS
BM30/400
BM30/300/HS
BH30/804/R
1. Select the position of the motor relative to the gate with the parameter
is with the motor installed on the right hand side of the gate (seen from interior side).
LEFT OPENING
2. Adjust the (mechanical or magnetic) limit switches so that, once triggered, the gate stops slightly before it
reaches the mechanical stop.
CLOSING LIMIT SWITCH
3. Check that the operator present function is not enabled (
OPEN STOP CLOSE
4. Move the gate into the closed position.
5. Press TEST (see TEST mode in chapter 10) and check the command signal and safety device states. If any
safety devices are not installed, jumper the relative contact or disable the device from the relative parameter
( , , , , and
Reversible Motor
MOTOR TYPE
/ /
/ /
see chapter 14 "Special Parameters for High Speed Motor"
/
see chapter 14 "Special Parameters for High Speed Motor"
see chapter 15 "Special Parameters for Reversible Motor"
RIGHT OPENING
OPENING LIMIT SWITCH
).
.
CONFIGURATION
. The default setting for this parameter
).
71