2. I
NSTALLATION
2.1. Unloading
2.1.1 Safety during unloading
In order to unload generating sets from their transport mountings, under optimum conditions
of safety and efficiency, you should check that the following points are being followed
correctly.
- Suitable lifting vehicles or equipment for the work.
- Slings positioned in the rings provided for this procedure or lifting arms resting fully
underneath the frame cross beams.
- Suitable ground to accommodate the load of the set and lifting vehicle, without strain (if not,
put down sufficiently strong and stable boards).
Remove the set as close as possible to its place of use or transport, in a clear space with free
access.
2.1.2 Example of material
- crane, slings, lifting beam, safety hook, shackles.
- fork lift truck.
2.1.3 Instructions for unloading
2.1.3.1 Slings
- attach the lifting vehicle slings to the rings on the generating set designed for this procedure.
- hang the slings carefully.
- check that the slings are correctly attached and the equipment is solid.
- lift the generating set carefully.
- direct and stabilise the set towards the chosen position.
- carefully set down the equipment while continuing to position it.
- release the slings, then detach and remove the lifting rings.
- 16 -