Wheel Circumference; Unit; Name; Factory Settings - Bosch Drive Unit Speed Manual Original

5.3.2.4 Wheel circumference

Pressing the Set button will take you to the section for
adjusting the wheel circumference. This can be set to any
value between 1510 mm and 2330 mm by pressing the
two arrow keys. Pressing the Set button confirms your
selection and then takes you back to the menu sub-item
display.
A change to the setting becomes necessary, for ex-
ample, when you have the tyres on your Pedelec
exchanged for some of a different size. In order to
continue to display the correct data, the new wheel
circumference must be entered.

5.3.2.5 Unit

Under the sub-item "Unit", you can choose whether in-
formation relating to distance travelled and speed is dis-
played in kilometres (km) or miles (mi). Using the arrow
keys on the control panel, select the option "km" or "mi".
Pressing the Set button confirms your selection and then
takes you back to the menu sub-item display.

5.3.2.6 Name

Under the sub-item "Name", you can enter a name or some
text with a maximum of 21 characters which will be dis-
played when the LCD display is turned on or off.
› To write, select one letter at a time from the alpha-
bet displayed using the arrow keys and confirm
your selection by pressing the Set button. The
letter then appears in the text line above the row
of letters. At the end of the row of letters, you can
select a hyphen or an underscore and confirm by
pressing the Set button.
› Errors can be corrected by selecting the right-hand
arrow and pressing the Set button. You can only
delete one letter each time.
22 V User Manual Impulse Pedelec
› You can switch between lower case and capital let-
ters by selecting "abc ... / ABC ..." on the right of the
display panel and pressing the Set button to con-
firm. The letters then immediately appear as lower
case or capital letters.
› The use of spaces is not possible and underscores
must be used in their place.
› By selecting "OK" using the two arrow keys on the
control panel and confirming using the Set button,
your entry is accepted and you are then taken back
to the menu sub-item display.

5.3.2.7 Factory settings

Under the sub-item "Factory settings", you are asked
whether you want to restore the settings which were pre-
set upon leaving the factory. If you wish to do so, select
the option "Yes" using the arrow keys on the control panel
and then press the Set button to confirm your selection.
Then you will be taken back to the menu sub-item display
once more. If you select and confirm the option "No", the
amended specifications remain in effect and you are, like-
wise, taken to the menu sub-item display once more.

5.3.2.8 Software

Via the sub-item "Software" you can access the sub-items
"Version" and "Update", which can be selected using the
arrow keys on the control panel.
› Pressing the Set button takes you to the respective
sub-item.
› By selecting the sub-item "Back" and pressing the
Set button to confirm, you are taken to the menu
sub-item display once more.
› The version of the motor software which is cur-
rently installed is displayed under the item "Ver-
sion". By pressing the Set button once again, you
are taken back to the menu sub-item display.
› Under the sub-item "Update", you can bring the
software up to date. A memory card is essential
for carrying out an update. If this is not present, a
message will be displayed to say that you need a
memory card. By pressing the Set button, you
return to the menu sub-item display.