Mounting And Removal Of The Display; Display Of The Power-Assist Mode And Energy Recovery - Bosch Drive Unit Speed Manual Original

5.2.1 Mounting and removal
of the display
Mounting:
Place the display on the display holder at an angle of
approx. 30 degrees.
Using light pressure, turn the display through 30 degrees
in a clockwise direction so that both components are
aligned with one another. In the process, you can clearly
feel the display lock into place.
Mounting the display
Removal:
Turn the display approx. 30 degrees anticlockwise on the
display holder. In doing so, the electrical connections are
undone and the display can be removed.
Removing the display
Please always turn the display off first before you
remove it (➠ Chapter 5.1.1 "Switching on/off").
› In order to protect your Pedelec from undesir-
able use by third parties or theft, the display
should always be removed from the handlebar
when the Pedelec is not in use.
› You can protect the display from theft by means
of a self-tapping countersunk screw for plastic.
Contact your specialist cycle shop about this.
5.2.2 Display of the power-assist mode
and energy recovery
You can also find information on the assist modes in
➠ Chapter 6.2 "Assist modes".
The selected assist level is displayed graphically on the
far left of the display. Above the diamond you will see the
assist levels 1 to 5. The higher the selected assist level,
the more assistance the drive provides with constant
pedal force.
Assist levels
Below the diamond, the energy recovery is displayed.
You can set two different recuperation levels. The first
level yields 50% energy recovery, while the second yields
100%. In the second level, the maximum possible energy
recovery is achieved.
VIII User Manual Pedelec Xion 15