Control Panel; On/Off Button; Switches For Power-Assist Level - Bosch Drive Unit Speed Manual Original

5 Control panel

1
1 Button for power assist level
2 On/Off switch
3 Power-assist mode display
4 Battery charge state indicator
The control panel on the handlebar has two or three but-
tons (depending on the model) and two rows of LED indi-
cators. The button used to control the level of assistance
is located on the left-hand side of the control panel.
To the right at the bottom you can see the LED display bar
which indicates the level of assistance which has been
activated and the current battery charge state.
The POWER button is located above the LEDs.
Press this button to switch the control panel on and off.

On/Off button

If the model features pushing assistance, the switch for
this will be on the underside of the control panel.
Button for pushing assistance
5.1
Press the POWER button to switch the control panel on
and off.
After it has been switched on, the system is always in the
2
medium power-assist mode SPORT.
3
4
5.2
You can specify the power assist level via the Mode
button.
Buttons for power assist level
Each time you press the Mode button the power assist
changes by one level.
Each time you press the Mode button, the assistance
changes by one level from ECO through to the highest level
POWER.
If you require less assistance, press the Mode button until
the level of assistance moves from the highest back to the
lowest level.
On/Off button

Switches for power-assist level

VII User Manual | Pedelec Groove 9