Charging The Battery; Charging Operation; Fitting The Battery - Bosch Drive Unit Speed Manual Original

3 Charging the battery

To charge the battery, you have to take it out of the holder
on the Pedelec.
Carry handle
Battery charge
state indicator
Grip the battery by the handle, insert the key into the lock
and turn it anticlockwise. The battery is now unlocked and
can be removed from the Pedelec by tilting it sideways.
In doing so, hold on tight to the battery to prevent it from
being dropped.
Unlocking the battery
Tilt to remove
You should now remove the key and keep it in a safe place
to prevent it from breaking off or being lost.
3.1

Charging operation

Before charging the battery, read the information on the
charger carefully.
› 1. Take the charger provided out of its packaging
and plug the mains plug into a socket (230 V, ob-
serve type plate on the charger).
Type plate on charger: Front and back
› 2. Put the battery in the docking station of the
charger.
› 3. The charging operation starts. The battery LEDs
light up or flash. Once all 5 LEDs have gone out, the
battery is fully charged. You can leave the battery
standing in the charger. However, the charger al-
ways draws some current if you leave it plugged in.
› 4. To save power, pull the charger plug out of the
socket once the charging operation is complete.
3.2

Fitting the battery

› 1. Insert the battery into the battery holder of
the Pedelec from the left by tilting it outwards at
roughly 45°.
› 2. In doing so, you must insert the lateral guides
at the bottom of the battery into the guides of the
holder.
› 3. Tilt the battery towards the bike until it en-
gages in the locking mechanism. If the key is still
in the lock, turn it clockwise then pull it out to lock
the battery in place.
› 4. Make sure the battery is firmly in place.
IV User Manual Pedelec with front motor 9