Filtering Oil - Angelo Po 091FR1ID Manual De Uso Y Instalación

4 - Press key (C) to activate the temperature input
mode.
5 - Press keys (F-G) to set the cooking temperature.
the data set on the control panel are retained in
the memory until the electricity supply is turned
off.
6 - Press key (E) to terminate the temperature
maintenance function.
7 - Press button (B) to start the cooking cycle.
Lights (P-Q) flash while the oil is heating to the
temperature of use, and then remain constantly
on.

FILTERING OIL

To carry out this operation, proceed as follows.
Important
Before proceeding, allow the appliance to
cool for 10÷15 min., so that the oil reaches
a temperature between 50÷120°C.
1 - Open the hatch (A).
2 - Fit the extension (B) onto the tap (C).
3 - Place the container (D) and the filter (E), both
available as optionals, underneath the exten-
sion (B).
4 - Turn on the tap (C) to empty the well.
5 - Turn off the tap (C) on completion of the opera-
tion
6 - Close the hatch (A).
Caution - warning
Do not dump oil in the environment; dispose
of it in accordance with the laws in force in
the country of use.
P B
C F
- 13 -
8 - To display the temperature set during cooking,
press key (C).
Stopping
1 - Press key (B) to stop the cooking cycle.
Important
If the electricity supply is cut off for less
than 20-40 seconds, the cooking cycle re-
starts automatically.
If the blackout lasts more than 40 seconds,
press key (B) to restart the cooking cycle.
A Q
E
G
C
B
IDM-39619400700B.tif
A
C
IDM-39619400800.tif
IT
GB
DE
FR
ES
E
D
English