Starting Up The Product; Connecting To Grundfos Go Remote; Startup Wizard On Grundfos Go Remote; Startup Wizard On The Operating Panel - Grundfos LC 231 Manual Del Usuario

3. Depending on the type of alarm device, connect
the wires to the relevant terminals. Note that all
wires must be secured inside the cabinet using
cable ties.
• NO (Normally Open) and C (Common)
• NC (Normally Closed) and C (Common).
4. Tie the wires with cable ties.
NC

3. Starting up the product

3.1 Connecting to Grundfos GO Remote

1. Open Grundfos GO Remote on your device.
Make sure that Bluetooth is enabled.
Your device must be within reach of the product
to establish Bluetooth connection.
2. Press the Bluetooth CONNECT button on
Grundfos GO Remote.
3. Press the connect button on the operating panel.
The blue LED above the connect button is
flashing blue until your device is connected.
Grundfos GO Remote is now loading the data for
the product.
Related information
3.4 How to enable Bluetooth on the operating panel
3.5 How to disable Bluetooth on the operating panel

3.2 Startup wizard on Grundfos GO Remote

The product is designed for Bluetooth communication
with Grundfos GO Remote.
Once you have connected your product to Grundfos
GO Remote, a startup wizard appears. Follow the
instructions to make your settings.
Grundfos GO Remote enables you to set functions
and gives you access to status overviews, technical
product information and current operating
parameters.
10

3.3 Startup wizard on the operating panel

The first time the control unit is switched on, a startup
wizard will guide you through the basic settings. You
can select the sensor type and sensor levels. For
some products, you can also set the nominal pump
current and number of phases.
If you have an analog sensor, select S-1 and set the
height of the different levels, from dry running to high
level.
If you have a digital sensor, select S-2 and enable or
disable the dry-running level, the start level for pump
2, if available and the high level.
To change settings, use the Up and Down buttons on
the operating panel.
Use the OK button to confirm each setting and
navigate to the next setting.
For filling applications, you must use Grundfos GO
NC N NO
Remote.
Units can only be changed with Grundfos GO
Remote.
Designation Description
S-1
S-2
-- A
1Ph
3Ph
Related information
6.1 Setting the application type with Grundfos GO
Remote
6.22 Starting the startup wizard with the operating
panel
3.4 How to enable Bluetooth on the
operating panel
If the Bluetooth signal on the operating panel has
been disabled for some reason, you are not able to
connect with Grundfos GO Remote. You must enable
Bluetooth first.
1.
2.
3.
Analog sensor
Digital sensor
Nominal current (see the nameplate
of the pump)
Single-phase
Three-phase
Press and hold the connect button on the
operating panel for 15 seconds. Wait for the blue
LED to light up.
Press the Bluetooth CONNECT button on
Grundfos GO Remote.
Press the connect button on the operating panel.
The blue LED above the connect button is
flashing blue until your device is connected
Grundfos GO Remote is now loading the data for
the product.