Ivoclar Vivadent bluephase C8 Manual Del Usuario página 11

HIGH POWER Program
Consistently high light intensity for the poly-
merization of restorative and cementation
materials for direct and indirect restorations.
800 mW/cm 2
0 t [s]
LOW POWER Program
Reduced light intensity with reduced heat
development for the polymerization of adhe-
sives, liners, and restorative materials in areas
near the pulp when restoring Class V cavities
650 mW/cm 2
0 t [s]
SOFT START Program
Step-by-step increase of the light intensity
with reduced shrinkage stress and reduced
heat development for the polymerization of
restorative materials
800 mW/cm 2
650 mW/cm 2
0 5 t [s]
1) Applies to a maximum layer thickness of 2 mm and provided that the Instructions for Use of the respective material do not state any other recommendation (might be the case with dentin shades)
2) Applies to a maximum layer thickness of 3 mm 3) Applies to light-curing (exclusive use of base paste)
Curing program
Light intensity
Max. exposure time for composites
Max. exposure time for Tetric EvoCeram
Filling materials
Composite
Tetric EvoCeram / Tetric EvoFlow /
IPS Empress Direct
Artemis / 4 Seasons, InTen-S,
Tetric new, Tetric N-Ceram / Tetric N-Flow
Heliomolar / Heliomolar HB / Heliomolar Flow
Others 1)
Compomer 2)
Compoglass F / Compoglass Flow
Indirect restorations /
Luting materials
Variolink II 3) , Variolink Veneer 3)
Variolink Ultra 4) , Multilink Automix 4) ,
Dual Cement 4)
Miscellaneous
Helioseal / Helioseal F / Helioseal Clear
Monopaque
MultiCore Flow / Multicore HB
CoroSeal
CoroSeal Bonding
Vivaglass Liner
Adhesive
AdheSE , AdheSE One, AdheSE One F
ExciTE, ExciTE DSC
Tetric N-Bond
Syntac / Heliobond
Temporary materials
Systemp.link
Systemp.inlay/onlay
Fermit / Fermit N
Miscellaneous
Heliosit Orthodontic
Filling materials
Composite
Tetric EvoCeram / Tetric EvoFlow /
IPS Empress Direct
Artemis / 4 Seasons, InTen-S,
Tetric new, Tetric N-Ceram / Tetric N-Flow
Heliomolar / Heliomolar HB / Heliomolar Flow
Others 1)
Compomer 2)
Compoglass F / Compoglass Flow
4) Applies to dual-curing
®
bluephase C8
800 mW/cm 2 ± 10%
20 sec.
15 sec.
Curing time
15 sec.
20 sec.
40 sec.
per mm ceramic: 10 sec. per segment
10 sec. per segment
20 sec.
30 sec.
40 sec.
20 sec.
10 sec.
20 sec.
10 sec.
10 sec.
10 sec.
10 sec.
20 sec.
20 sec.
25 sec.
25 sec.
13