Switching The Engine Off; Cutting Techniques - Hilti DSH 700 Manual Del Usuario

6.1.2 Starting the engine
DSH 700-X
DSH 900-X
1. Press the decompression valve (once).
2. When starting the cold engine (only when cold), squeeze the primer bulb 2 to 3 times (until the primer
bulb is completely filled with fuel).
3. Press the throttle safety grip and keep it pressed.
4. Press the throttle trigger and keep it pressed.
5. Move the start/stop switch to the "start" position.
6. Release the throttle safety grip and throttle trigger.
◁ This half-throttle position is activated.
7. Check that the cutting disc is free to rotate.
8. Position your right foot over the lower part of the rear grip.
9. Pull the starter handle slowly with your right hand until resistance is felt.
10. Pull the starter handle vigorously.
11. Repeat this action until the engine starts.
12. Press the throttle trigger briefly as soon as the engine starts.
◁ This disengages the half-throttle position and the engine then runs at idling speed when the throttle
is released.
6.2 Checks after starting the engine
1. Check that the cutting disc remains stationary when the engine is idling and, after briefly running at full
speed, that the disc again comes to a complete standstill.
◁ Readjust (reduce) the idling speed if the cutting disc doesn't stop rotating when the engine is idling.
If this is not possible, please bring the product to Hilti Service.
2. Check that the start/stop switch is functioning correctly. Move the start/stop switch to the "stop" position.
DSH 700
DSH 900
▶ If the engine doesn't stop, push the choke lever upwards. If the engine still doesn't stop, pull the
spark plug connector off the spark plug and bring the product to Hilti Service.
DSH 700-X
DSH 900-X
▶ If the engine doesn't stop, compress the primer bulb. If the engine still doesn't stop, pull the spark
plug connector off the spark plug and bring the product to Hilti Service.

6.3 Switching the engine off

WARNING
Risk of injury. A rotating cutting disc can break or shatter, possibly resulting in flying fragments.
▶ Allow the rotating cutting disc to come to a complete standstill before you lay the saw down.
1. Release the throttle trigger.
2. Move the start/stop switch to the "stop" position.
◁ The engine stops.

6.4 Cutting techniques

In order to work optimally with this product, the following safety instructions must be observed:
• Always hold the product and the saw trolley with both hands on the grips provided. Keep the grips dry,
clean and free from oil and grease.
• Before beginning the work, or if an obstacle was previously inadvertently contacted, check the cutting
disc and guard immediately for possible damage.
• Check that no persons are present in the working area and, in particular, in the direction in which the cut
is to be made. Keep other persons approx. 15 m away from your workplace.
• Guide the product smoothly and do not apply lateral pressure to the cutting disc.
34
8