Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
9.2 - Total or partial deletion of the memory using a transmitter not memorised
This procedure enables deletion of: a) all memorised data, including limit positions "0" and "1" (restoring all factory settings), or , b) deletion of transmitters
only. To select which items to delete, take care to observe point 07 of the procedure.
Warning – To cancel the procedure during execution, press buttons n and t on the transmitter at the same time and hold them until the blind carries out 6
movements, then release the buttons.
01
02
OFF
06
3
5
sec.
01. Disconnect the power supply
02. Connect the White and White-Black wires.
03. Connect the power supply
04. (on the transmitter) Press and hold button n for a few seconds and
release it after the blind has completed 2 movements.
05. (on the transmitter) Press and hold button n for a few seconds and
release it after the blind has completed 4 movements.
06. (on the transmitter) Press and hold buttons s and n for a few seconds
and release them after the blind has completed 3 movements.
9.3 - Total deletion of the memory using a wall-mounted 2-button panel
This procedure enables deletion of all memorised parameters, restoring all factory settings. To perform this procedure, a 2-button control panel is required.
Mechanical operation of the buttons must enable the user to press them simultaneously.
Warning – To cancel the procedure during execution, press buttons n and t on the transmitter at the same time and hold them until the blind carries out 6
movements, then release the buttons.
01
02
Withe-orange
OFF
Withe
Withe-Black
01. Disconnect the power supply
02. Connect the motor to a 2-button panel as shown in the top figure.
03. Connect the power supply
04. (on the pushbutton panel) Press and hold the Up and Down pushbut-
tons simultaneously after the blind has completed 1 movement, then
release the Down button only; after this press the Down button three
times and then release the Up button.
03
04
White
ON
White-Black
all
data
only
Com.
05
2
5
sec.
07
3
5
sec.
07
5
THE
END
To delete all data:
07. (on the transmitter) Press and hold buttons s and t for a few seconds
and release them after the blind has completed 3 movements.
To delete transmitters only:
07. Wait for the blind to complete 5 movements.
03
04
ON
. . .
sec.
4
5
sec.
THE
END
1
x 3
THE
END
English – 10
Publicidad
Tabla de contenido
