Nice For-Max Video Screen Instrucciones Y Advertencias Para La Instalación Y El Uso página 5

6.2 - Manual setting of the Up (0) and Down (1) Limit Positions
(procedure suitable for blinds without mechanical stops or casings on closure)
This procedure envisages the programming of the UP limit position ("0" = maximum Up position of the fabric) and then of the DOWN limit position ("1" = max-
imum Down position of the fabric).
Warnings:
– During the procedure, at the start of the movement the blind performs two short interruptions in the movement to signal that the two limit positions are not
programmed; otherwise it carries out one short movement interruption to signal that just one limit position is programmed.
– To cancel the procedure during execution, press buttons n and t on the transmitter at the same time and hold them until the blind carries out 6 move-
ments, then release the buttons.
6.2.1 - Manual setting of the UP ("0") limit position
01
04
2
5
sec.
Before starting the procedure, set the blind to mid-travel.
01. (on the transmitter) Press and hold button s (or t) until the blind almost
reaches the required position of the UP limit ("0"), then release the but-
ton.
02. (on the transmitter) Press and hold button n for a few seconds and
release it after the blind has completed 2 movements.
03. (on the transmitter) Press and hold button n for a few seconds and
6.2.2 - Manual setting of the DOWN ("1") limit position
01
04
2
5
sec.
Before starting the procedure, set the blind to mid-travel.
01. (on the transmitter) Press and hold button t (or s) until the blind almost
reaches the required position of the DOWN limit ("1"), then release the
button.
02. (on the transmitter) Press and hold button n for a few seconds and
release it after the blind has completed 2 movements.
03. (on the transmitter) Press and hold button n for a few seconds and
––––––––––
Note - After this programming procedure button s will control the Up movement and button t the Down movement.
"0" 02
5
sec.
05 "0" 06
(optional)
"1" 02
5
sec.
05 "1" 06
(optional)
03
2
3
5
sec.
release it after the blind has completed 4 movements.
04. (on the transmitter) Press and hold button s for a few seconds and
release it after the blind has completed 2 movements.
05. Optional setting of UP position "0": briefly press transmitter buttons
s and t to move the blind to the required limit position (the blind
moves a few millimetres each time the button is pressed).
06. (on the transmitter) Press and hold button n for a few seconds and
release it after the blind has completed 3 movements.
03
2
3
5
sec.
release it after the blind has completed 4 movements.
04. (on the transmitter) Press and hold for a few seconds button t and
release it after the blind has completed 2 movements.
05. Optional setting of DOWN position "1": briefly press transmitter but-
tons s and t to move the blind to the required limit position (the blind
moves a few millimetres each time the button is pressed).
06. (on the transmitter) Press and hold button n for a few seconds and
release it after the blind has completed 3 movements.
4
5
sec.
THE
END
4
5
sec.
THE
END
English – 4