Blatchford Elan Serie Manual De Instrucciones página 15

9.2 Bluetooth® Connection to the Elan [Start]
1 Ensure the Elan is charged up and the
Bluetooth® Dongle is connected to the
Elan and flashing Blue*.
2 Select the paired port for the Elan
Dongle from the pull down menu.
If this dongle has been used previously
you can use [Autoconnect]
When connected, the Dongle LED will
change to green and the Bluetooth
symbol on the status bar will change to
active.
C
*Note
If you have just paired the Bluetooth Dongle it may
be necessary on some remote devices to disconnect
and reconnect the Bluetooth Dongle to the Elan
before making the Bluetooth connection from the
software interface.
A
B
B
Status Bar
To return to this screen
click on:
C
Where it is not possible
to make a Bluetooth
connection use the Comms
Cable via a USB port on the
laptop.
See Section 13 for software
driver installation procedure
and instructions for using the
Comms Cable.
A
D
[Disconnect]
D
To disconnect the Bluetooth® Dongle from
the PC/Laptop
[System Reset]
E
Resets the software in the Elan if the
Bluetooth® connection is interrupted
13
Start
Bluetooth
E
938317S/3-0719