Extraction And Insertion Of The Chronothermostat - ABB 2CLA234009N234001 Instrucciones De Instalación, Uso Y Mantenimiento

INSTALLATION
6.5 Extraction and insertion of the
chronothermostat
Operation required to replace the batteries, use internal buttons
for programming, etc.
Programming ease
All programming operations can be carried out before inserting
the chronothermostat module into the recessed base. This
allows the programming to be done while sitting comfortably.
The flashing fixed winter or summer signal indicates that the
chronothermostat is outside of the recessed base.
ATTENTION: If the chronothermostat module has been
programmed before it is fixed to the recessed base,
after the installation has been completed, the display's
ON indication (off or flashing) might not correspond
to the real status of the relay. Within a maximum of 1
minute from fixing the chronothermostat to the base
in the wall, the relay will be activated according to the
indication (off or flashing) present on the display
Chapter 6
Extract the
chronothermostat
module by gripping
it with the fingers in
the corresponding
notches.
nsert or replace 2 batteries of 1.5V type AA-LR6 paying
attention to the poles
USE GOOD QUALITY ALKALINE BATTERIES
(Duracell or Energizer recommended
ATTENTION: the batteries may last for more than 2
years. Therefore, we recommend replacing them at
least every 24 months to prevent them from running
out during periods of absence (e.g. Christmas
holidays, etc.)
22
ON 20
18
16
14
Se t 12
10
8
6
4
2
0
Reinsert the chronothermostat completely into the recessed
base.
ABB ABB
Dispose of the batteries
b y p l a c i n g t h e m i n
c o n t a i n e r s i n t e n d e d
for this purpose, and
therefore, in accordance
w i t h e n v i r o n m e n t a l
conservation regulations.
21 21 21 21