Activation / Deactivation With Telephone Programmer - ABB 2CLA234009N234001 Instrucciones De Instalación, Uso Y Mantenimiento

ABB ABB
12.10.1 Activation / deactivation with telephone
programmer
Once the telephone programmer (optional) is connected to the chronothermostat
or other command device, it will be possible to select the type of contact NO or NC
present on board the telephone programmer.
Following the path: button Menu -> CONFIG SEt -> when the INPUT SEt element
is displayed, press the «OK» button and use the buttons to select the element
TELEPHONE nC or TELEPHONE nO. Press the «OK» button to confirm. Press
the back button to exit.
e.g. Telephone programmer (NC
contact)
e Close contact
e Open contact
e.g. Telephone programmer (NO
contact)
e Close contact
e Open contact
72 72 72 72
Chronothermostat operation
in OFF mode with t1 antifreeze
in permanent manual mode with
t(1) comfort
Funcionamiento del
cronotermostato
in permanent manual mode with
t(1) comfort
in OFF mode with t1 antifreeze
CONFIGURATION MENU
Chapter 12