No Connection To An Additional Sensor; Adjustment Of The Additional Remote Sensor - ABB 2CLA234009N234001 Instrucciones De Instalación, Uso Y Mantenimiento

ABB ABB
CONFIGURATION MENU

12.9.1 No connection to an additional sensor

If it is required disable the previously active additional temperature sensor and to
return to using just the internal standard one (by default), follow these steps: following
the path of the button Menu -> CONFIG SEt -> SENSOR Set -> select the element
SENSOR nO (NO) and press the OK button to confirm.
Press the back button to exit.
Reading range of the internal sensor: -5.0 °C ˜ +37.7 °C (+23.0 °F ˜ +99.9 °F)

12.9.2 Adjustment of the additional remote sensor:

This is a remote sensor for detecting the temperature in an environment other than
the one in which the chronothermostat is installed, for example, in the event of an
unfavourable installation or in premises unsuitable for reading and controlling the
temperature. The remote sensor has the same parameters and reading range as
the internal sensor. Reading range: -5.0 °C*+37.7 °C (+23 °F*+99.9 °F).
Completely replaces the chronothermostat's internal sensor and the product will
adjust the temperature control of the environment using this remote sensor.
Once the remote temperature sensor has been connected to the chronothermostat,
it will be possible to activate it following the path: button Menu -> CONFIG SEt ->
SENSOR Set -> select the element REMOTE.
Press the «OK» button to confirm. Press the back button to exit.
68 68 68 68
Chapter 12