Adjustment Of The External Additional Sensor - ABB 2CLA234009N234001 Instrucciones De Instalación, Uso Y Mantenimiento

ABB ABB
CONFIGURATION MENU

12.9.4 Adjustment of the external additional sensor

This is an additional sensor that allows the outdoor temperature of the house to be
read (tE). It has no house temperature control functions, which are managed by the
chronothermostat's onboard internal sensor. Once the external temperature sensor
has been connected to the chronothermostat, it will be possible to activate it following
the path: button Menu -> CONFIG SEt -> SENSOR Set -> select the element
EXTERNAL. Press the «OK» button to confirm. Press the back button to exit.
Reading range of the external sensor: -9.9 °C ˜ +60.0 °C (+14.2 °F ˜ +140.0 °F)
If the value of 99.9 °F is exceeded (on the Fahrenheit scale) the decimal points
are deleted.
NOTE: in stand-by mode, every 10 seconds the display will alternate
the external (outdoor) temperature reading (tE) with the value of the Set
temperature setting at that moment.
every 10 sec.
70 70 70 70
Chapter 12