Immediate Activation Of Most Frequently Used Functions - ABB 2CLA234009N234001 Instrucciones De Instalación, Uso Y Mantenimiento

IMMEDIATE ACTIVATION OF MOST FREQUENTLY USED FUNCTIONS

8 IMMEDIATE ACTIVATION OF MOST
FREQUENTLY USED FUNCTIONS
From the normal functioning of the chronothermostat in stand-by, when pressing
a button the display will light up (unless the backlight has been disabled) and the
selection and navigation possibilities are displayed. Within a 6-second interval,
every time the required button is pressed a change is made.
NOTE: with the backlight setting always on (section
modification"), the selection and navigation possibilities will also be visible
always.
With the chronothermostat in this state, certain USE functions (normally the ones
most frequently used) can be quickly enabled without necessarily having to open
the specific menus:
Temporary manual operation (consult the full description in section
operation")
Pressing button 2 or 3 will activate the temporary manual forcing (suspension
of the running program): symbol 6 and the running temperature setting will appear
flashing. Pressing the buttons 23 allows the required independent temperature
to be set. After 4 sec., or by pressing the OK button, the screen will display h 01 (by
default) and the buttons will become
during which the temporary manual functioning should last: from 1h to a maximum
of hours ranging from the time of the forced activation until midnight (the digits
corresponding to the set hours flash).
At the end of the set number of hours, the chronothermostat will return
to the normal functioning of the program that was running before the
temporary manual forced operation was entered.
Therefore, it will be possible to exit the temporary manual operation early, by
pressing the button back.
Chapter 8
"12.2 Language setting
. It is possible to set the number of hours
"11.2.1 Manual
ABB ABB
25 25 25 25